Flame Detector
Install Cig-Arrete products Today
Cigarette Bins
PDF Downloads

CSA-FDV

The Stand-Alone Flame Detector used a single detector or supplied via a CSA-DBD and Power supplies CSA-SMPSU or CSA-246 . Remote sounders can be connected to give indication to staff of an alarm

CSA-DBD

The unit comprises an integral Cig-Arrete Flame detector and voice sounder module, which provides a voice message when a lighter or match is detected. "This is a no smoking area, please extinguish your cigarette, a member of staff has been contacted" Battery operated using 4 x AA alkaline batteries, the CSA-FDV can be simply screwed to the ceiling and is capable of detecting a 25mm flame at a distance of 6 metres within 1 second.

 CSA-FUV

The new flame detector can be use in areas where a standard Cig-Arrete detector would be unable detect smoke                  ( Entrances or Lobbies ) use with a full system or part of a master / slave system.

 CSA-S5B

The Cig-Arręte Flame Sensor is at the heart of the system. Continually analysing the environment for a source of flame from a match or lighter, the sensor provides an alarm if a naked flame is detected. The CSA-FUV is capable of detecting a 25mm flame at a distance of 6 metres within 1 second. The CSA-FUV is manufactured from tough brilliant white GRP plastic.

  Economy Versions ( Single area not bigger than 3m x 3m )

 CSA-FDV/E

The Simple Cig-Arrete Solution ( Battery operated ( 1 x PP3 )
  • 1 x CSA-FDV / E complete with vandal cage.
  • No installation required.
  • Message in alarm broadcast in toilets to patrons.
  • Vandal cage avoids tampering.
  • Discharges responsibility under New smoke Free Legislation.
  • Battery operated only.

Use this solution if your toilet / washroom is less than 3m ( 9 ft ) square floor area. The message will be played upon detection of the flame from a match or lighter instructing the smoker to extinguish their cigarette.Supervisory staff will not be alerted using this system.